Booster Bath Assembly Instructions


  • Booster Bath Assembly
  • Dual Hose Assembly
  • Groomer Ramp Assembly

Booster Bath Assembly Instructions

Dog Bath Process Booster Bath Assembly Steps for Booster Bath
1. Push "stainless steel bolts" through four holes in bottom of tub. 2. Attach plastic bolt caps using small Philip screws. 3. Insert "rubber-bumper" in cavity at bottom of each leg.
Dog Washing Steps Boosterbath assembly process
4. Turn tub over and place "legs" over bolts. Spin "five star knobs" on bolts firmly, when complete, turn tub upright. 5. Flex "shampoo caddy" into it's three hole location starting with bottom hole. 6. Place "leash restraint" in "T" configuration in bottom of tub as shown.
Dog Bath Instructions durable dog bathing
7. Place thick washer over end of eyehook and push through sidewall of tub, spin on five start knobs firmly. 8. Place o-ring on fitting and attach "discharge hose" by pushing through large hole in rear of tub and securing with threaded cap.  

Dual Hose Assembly Instructions

Hose Assembly 1 Hose Assembly 2 Hose Assembly 3
1. Flip tub upside down and
attach 5' hoses to chrome
"Y" loosely.
2. Attach male portion of quick
connect to chrome "Y" and
tighten with pliers.
3. Zip-tie chrome "Y" to bottom
of tub with male portion of quickconnect facing rear of tub. Note: zip-ties go across
brass collar on hose as shown.
Hose Assembly 4 Hose Assembly 5 Hose Assembly 6
4. Cut off excess zip tie with
scissors/cutters and flip tub
upright..
5. Attach fan nozzles to 5' hoses using brass quick-connects. Note:
pillars are needed when installing male portion of quick-connect to fan nozzle.
6. Adjust hose referring to
above illustration and tighten
both hoses to chrome "Y"
firmly.
Hose Assembly 7 Hose Assembly 8
7. Attach female portion of
quick connect to water supply
hose.
8. Attach water supply hose via
quick connect referring to above illustration.
 

Groomer Ramp Assembly Instructions

Dog Bath Process Booster Bath Assembly  
1. Place thick plastic washer onto metal eyehook and push through hole located on side rail of ramp.
2. Firmly screw plastic 5 star knob onto eye hook.
3. Attach "Groomer Ramp Pedestal" to square tabs using metal screw and 5 star knob as shown. Note: In order for Pedestal to meet floor surface squarely it may be necessary to "flex" or bend the pedestal to proper location. Square plastic Ramp tabs are very strong so there is no need to worry that they may break.

Pedestal Assembly Instructions

Dog Washing Steps    
1. Place Booster Bath upside down and remove rubber bumpers from legs (if they have been installed). 2. A-line and place pedestals to legs as shown. 3. Using metal screws and 5 star knobs, attach Pedestals to legs as shown.

If you are a dog and your owner suggests that you wear a sweater... suggest that he wear a tail.
~Fran Lebowitz